Where all the latest news about HANALEI FINS can be found, we tend to put all of our announcements here, as well as information about new designs and the testing process.

Some of the historical blog posts from previous years are slowly being moved into the new blog. Initially, all of the most interesting ones will be moved over. Eventually we hope to get all of the old posts up here so they are accessible.

Most of the new posts also get placed on our Facebook page, so they can be read there as well.

WNG SINGLE Fin Assembly S2

WNG Wing Fin Assembly S2

Written by: | Posted on: | Category:

Now that the base plate has been added to the mast, we will add the bulking plates.

WNG Base Plate Attached

These bulking plates are used to increase the thickness of the wings to accommodate the upsweep angle and taper.

In the example shown in the photo, we are adding RED plates to contrast with the mast's MANGO color.

With the bulking process completed, the next step will be to block out the initial wing profile. This is where the hard work begins as there is a lot of material to remove.

Thursday June 1st, 2023
Friday May 26th, 2023


Primary office locations for HANALEI FINS - Australia and Hawai'i (USA). Contact info is provided here, but the preferred contact method is through the contact form on this site.

+61 2 4339 9580

+1 808 639 5303